Removing And Replacing Parts On The Net Pc Chassis; Recommended Tools - Dell OptiPlex GXa Service Manual

Chapter 7
Removing and Replacing Parts
on the Net PC Chassis
T
his chapter provides procedures for removing the components, assemblies,
and subassemblies in the OptiPlex NX Net PC chassis. If you are servicing a
low-profile, midsize, or mini tower computer, use Chapter 4, "Removing and
Replacing Parts on the Low-Profile Chassis," Chapter 5, "Removing and
Replacing Parts on the Midsize Chassis," or Chapter 6, "Removing and Replac-
ing Parts on the Mini Tower Chassis," as appropriate.
Unless otherwise noted, each procedure assumes the following:
•
You have performed the steps in "Precautionary Measures" found later in
this chapter.
•
You have removed the computer cover.
•
You can replace or reinstall a part by performing the removal procedure in
reverse order unless additional information is provided.
R
ecommended Tools
Most of the procedures in this chapter require the use of one or more of the fol-
lowing tools:
•
Small flat-blade screwdriver
•
Wide flat-blade screwdriver
•
#1 and #2 Phillips-head screwdrivers
•
-inch nutdriver
1/4
•
Tweezers or long-nose pliers
Also, use a wrist grounding strap as explained in the next section, "Precaution-
ary Measures."

Removing and Replacing Parts on the Net PC Chassis

7-1