Changing The Embroidering Position - Brother PR-600 Manual

Sapphire.book Page 70 Friday, August 1, 2003 9:12 AM
OTHER BASIC PROCEDURES

Changing the Embroidering Position

When the embroidery machine is purchased, it was adjusted so that the beginning of the stitching was from the
center of the pattern. Therefore, move the frame and adjust the embroidering position so that the center of the
pattern aligns with the needle drop point at the sewing position. In addition, the angle of the entire pattern can
be adjusted if the fabric cannot be hooped evenly within the embroidery frame and the pattern is positioned at
an angle on the fabric.
1 Touch , ,
and in the embroidering settings
screen.
Move the embroidery frame so that the needle
drop point is at the center of the area where
you wish to embroider.
The embroidery frame moves in the
opposite direction of the arrow.
The pattern in the pattern display area
moves in the same direction of the arrow.
1 Shows the vertical distance moved
2 Shows the horizontal distance moved
70
——————————————————————————————————————————————————
, , , ,
■ Finding the sewing position
1
• Touch to move the embroidery frame
back to its original position (where the
center of the embroidery frame is aligned
with the needle drop point at the sewing
position).
By locking the needle bar (securing the needle
and presser foot in the down position), the needle
drop point can easily be seen.
As shown in the illustration, insert the allen
screwdriver into the square hole in needle
clamp to slowly lower the needle bar down till
needle bar stops then clicks into the lock
position.
Note
● Make sure that the needle is not lowered
beyond the positioning click into the fabric.
The needle and presser foot are locked in
the down position.