Starting/Ending Position Settings - Brother PR-600 Manual

Sapphire.book Page 87 Friday, August 1, 2003 9:12 AM

Starting/Ending Position Settings

The machine can set the start point and the ending point separately from the 9 points of the pattern. Those are
upper-left corner, upper-center, upper-right corner, center-left, center-center, center-right, lower-left corner,
lower-center and lower-right corner.
These settings can be used to repeatedly sew a pattern along a diagonal.
The starting/ending position settings are specified
from the embroidering settings screen.
When the embroidery machine is purchased, both
the starting position and the ending positions are set
to the center of the pattern.
1
Touch .
The starting/ending position settings screen
appears.
1 Specifies the starting position
2 Specifies the ending position
Touch a key to select the setting.
The highlighted key shows the currently selected
setting.
Example
3 Touch this key to close this screen.
This key is selected.
■ Specifying the starting position
2
Touch the key for the desired starting position
setting.
When a starting position is selected, the
ending position is automatically set to the
same position.
The embroidery frame moves to the starting
position.
■ Specifying the ending position
3
Touch the key for the desired ending position
setting.
4 After selecting the desired settings, touch
.
The embroidering settings screen appears
again.
Memo
● The starting/ending position settings do not
change until the key for a new setting is
touched. The settings specified before the
machine is turned off remain selected the
next time that the machine is turned on.

Starting/Ending Position Settings

4
87