Remote Control; Before Operation - Aiwa XR-H66MD Operating Instructions Manual

REMOTE CONTROL
BEFORE OPERATION
Inserting batteries
Detach the battery cover on the rear of the remote control and
insert two R6 (size AA) batteries.
R6(AA)
When to replace the batteries
The maximum operational distance between the remote control
and the sensor on the main unit should be approximately 5 meters
(16 feet). When this distance decreases, replace the batteries
with new ones.
Using the remote control
The instructions in this manual refer mainly to the buttons on the
main unit. Buttons on the remote control with the same names
as those on the main unit can be used as well.
If the unit is not going to be used for an extended period of
time, remove the batteries to prevent possible electrolyte
leakage.
The remote control may not operate correctly when:
- The line of sight between the remote control and the remote
sensor Inside the display window is exposed to intense light,
such as direct sunlight
- Other remote controls are used nearby (those of a television,
etc )
,.
To turn the unit on
DIMMER
Press one of the function buttons (CD, MD, TUNER, TAPE, AUX/
D-IN).
Playback of the inserted disc begins, or the previously tuned
station
IS
received (Direct Play Function).
The POWER button is also available.
When the unit is turned on, the disc compartment may open and
close to reset the unit.
DEMO
(Demonstration) mode
When the AC cord is connected, the display window
demonstrates the functions of the unit. When the power is turned
on, the DEMO display is overridden by the operation display.
When the power is turned off, the DEMO mode is restored.
To
cancel
DEMO
mode
Press the DEMO button. The clock display appears. (To set
the current time, see "SETTING THE CLOCK on page 30.)
Tore-activate the DEMO mode, press the DEMO button again.
Illumination guidance
Buttons light when they can be operated and flash during an
operation.
To
turn off the CD light
Press the CD button while pressing the button. Repeat the
same operation to restore the light.
To turn off the MD light
Press the MD button while pressing the button. Repeat the
same operation to restore the light,
About the DIMMER button
Press the DIMMER button on the remote control once to dim the
display. Press it a second time to turn off the spectrum analyzer
indications on the display, the CD and MD lights, and illumination
of the DISC DIRECT PLAY buttons. Press It a third [Ime to restore
the display and buttons to their original brightness.
To turn
the
unit
off
Press the POWER button,
5
ENGLISH