Listening To External Sources; Care And Maintenance - Aiwa XR-H66MD Operating Instructions Manual

LISTENING TO EXTERNAL
SOURCES
/,
Ooooom:
. . . .. ..
~.
I
l;
r! .
To play equipment connected to the DIGITAL IN jack
Press the AUX/D-lN button repeatedly until "D-IN" is displayed.
Then start playback of the connected equipment.
To play equipment connected to the AUX jacks
Press the AUX/D-lN button repeatedly until "AUX is displayed.
Then start playback of the connected equipment.
To listen to the playback sound of a cassette deck
connected to the TAPE PLAY jacks
Press the TAPE button so that "TAPE" is displayed. Then start
playback of the connected cassette deck.
To change a source name in the display
When the AUX/D-lN button is pressed, AUX is displayed initially.
It can be changed to VIDEO or TV.
With the power on, press the POWER button while pressing the
AUX/D-lN button,
Repeat the procedure to select one of the names.
To adjust the sound level of the external source
When the sound level of the external source is much higher or
much lower than that of other function sources, adjust it as
follows.
1 Press the AUX/D-l N or TAPE button so that '(AUX or "TAPE"
is displayed, and start playback of the connected equipment.
2 Press the < or * button so that the sound level becomes
the same as that of other function sources.
During recording, the sound level cannot be adjusted.
When an MD is loaded or the DISC CHECK button on the
remote control is pressed during playback of external equipment
connected to the DIGITAL IN jack, the playback sound becomes
inaudible while the unit is reading the TOC data of the loaded
MD.
CARE AND MAINTENANCE
Occasional care and maintenance of the unit and the software
are needed to optimize the performance of your unit.
To clean the cabinet
Use a soft and dry cloth.
If the surfaces are extremely dirty, use a soft cloth lightly
moistened with mild detergent solution, Do not use strong
solvents, such as alcohol, benzine or thinner as these could
damage the finish of the unit.
Care of CDs
When a CD becomes dirty, wipe the CD from the center out
with a cleaning cloth.
After playing a CD, store the CD in its case. Do not leave the
CD in places that are hot or humid.
Care of MDs
Since MDs come in a cartridge which protects the discs inside
from fingerprints and dust, you do not have to be overly careful
when handling them. However, soiled or damaged cartridges
can lead to malfunctions in the unit. Observe the following tips
when handling MDs.
Keep a cartridge in the attached case.
Do not open the shutter of the cartridge to touch the disc directly.
If the disc inside becomes soiled, it is very difficult to clean.
The cartridge can also be damaged.
Close the shutter if it opens while handling or ejecting a disc.
Otherwise dust may enter or a disc may become scratched.
Disc shutter
%
Cartrvdge
\
*1>,
ENGLISH 36