Creating A Static Arp Entry; Static Arp Configuration Example - 3Com Baseline 2928 PWR Plus User Manual

Creating a Static ARP Entry

Select Network > ARP Management from the navigation tree to enter the default ARP Table page
shown in Figure
Options checkbox to expand advanced configuration items, as shown in
Figure 1-4 Add a static ARP entry
Table 1-1 describes the static ARP entry configuration items.
Table 1-1 Static ARP entry configuration items
Item
IP Address
MAC Address
VLAN ID
Advanced
Options
Port

Static ARP Configuration Example

Network Requirements
As shown in Figure
interface GigabitEthernet 1/0/1 belonging to VLAN 100. The IP address of Router B is 192.168.1.1/24.
The MAC address of Router B is 00e0-fc01-0000.
To enhance communication security between Switch A and Router B, static ARP entries need to be
configured on Switch A.
1-3. Click Add to enter the New Static ARP Entry page. Select the Advanced
Type an IP address for the static ARP entry.
Type a MAC address for the static ARP entry.
Type a VLAN ID and specify a port for the static ARP entry.
The VLAN ID must be the ID of the VLAN that has already been created,
and the port must belong to the VLAN. The corresponding VLAN interface
must have been created.
1-5, hosts are connected to Switch A, which is connected to Router B through
Description
1-4
Figure 1-4.