Adjusting the Output Conditions of the Measurement Result
Setting the Average Number of Measurements
The average of the set number of measurements can be output as the measurement
result. Set this function to disregard sudden changes in the measurement values.
ADJ mode-MENU/VIEW key-[FILTER]-[AVE]
Setting value
1, 2, 4, 8, 16, 32. 64.
128, 256
Note
• To change numerical values, use the ↑ key/↓ key.
• The calculation method for the average values differs according to the measurement
trigger and sensitivity adjustment settings.
HSMULTI sensitivity
Moving average
Trigger disable
Trigger enable
Simple average
• Moving average: The average value is output from the past N number of results.
• Simple average: Measurement is performed for N number of times, and the average value
of these measurements is output.
Setting Smoothing
The intermediate value of past measurement results can be output as the measurement
value. This function removes any abnormal values, such as spiking, that occur when the
measurement result suddenly changes during measurement.
ADJ mode-MENU/VIEW key-[FILTER]-[SMOOTH]
Setting value
OFF, LOW, MID, HIGH
Important
Smoothing is invalid when the measurement trigger and sensitivity adjustment settings are
combined as follows. (Smoothing is not executed even if it is set.)
• Trigger enabled + MULTI sensitivity
• Trigger enabled + FIXED sensitivity
• Trigger enabled + HS MULTI sensitivity
ZG2 User's Manual
Description
Sets the average number of measurements. (default value: 1)
MULTI sensitivity
AUTO sensitivity
Moving average
Moving average
Moving average
Simple average
Description
Sets the smoothing strength. (default value: LOW) The
intermediate value of the past measurement values for the preset
filter value at each individual measurement cycle is set as the
measurement result.
Adjusting the Output Conditions of the Measurement Result
FIXED sensitivity
Moving average
Simple average
111