Table of Contents
Advertisement
2.
Install the mounting bracket to the installation location (2-M5 screw × 4)
• Do not apply stress to the cable when installing or using.
• The reading distance and angle ranges may differ depending on labels.
Before installing the reader, check that the label is read successfully.
• Be sure to install the supplied insulation board to reduce the influence of inductive noise on the
reader.
Use the attached screws to install the insulation board.
Insulation board
2-M5 screw
2-M5 screw
Section 2
Introduction Procedure
30°
30°
V400-R1CF/R1CS
User's Manual
41
Advertisement
Table of Contents
