Attach The Mechatrolink-Ii Interface Unit To The Servo Driver - Omron TJ1-MC04 Quick Start Manual

Connections
3.4.1 Attach the MECHATROLINK-II Interface Unit to the
Servo Driver
You can use a 200 V single-phase Servo Driver (see page 19) or a
400 V three-phase Servo Driver (see page 20).
1. Insert the clips (A) of the MECHATROLINK-II Interface Unit
(NS115) into the openings (B) of the Servo Driver.
2. Make sure the port (C) of the Servo Driver is located opposite to
the slot of the NS115.
3. Insert the clip (D) of the NS115 into the opening (E) of the Servo
Driver.
4. Connect the earth wire (F) of the NS115 to the point marked G
(G) on the Servo Driver.
QUICK START GUIDE
fig. 6
E
C
fig. 7
D
F
18