Operating Procedures; Setting Procedure Guide - Omron H5CX-N Datasheet

Operating Procedures

Setting Procedure Guide

Settings for Timer Operation
Use the following settings.
Settings for Twin Timer Operation
Refer to page 25.
* It is not necessary to mount the Waterproof Packing if waterproof construction is not required.
Operating Procedures for Timer Function
Step1
Settings for basic functions can be performed with just the DIP switch.
Note: There is no DIP switch on the H5CX-L8@. Go to
Key-protect Switch
Item
1 DIP switch settings
2
3 Time range
4
5
Output modes
6
7 Timer mode
8 Input signal width
Note: All the pins are factory-set to OFF.
Be sure to turn ON pin 1 of the DIP switch.
Changes to DIP switch settings are enabled when the
power is turned ON.
(Set the DIP switch while the power is OFF.)
After making DIP switch settings for basic operation, advanced functions can be added using the operation keys on the front panel. Refer to
Step2 on page 16 for details.
*
*
Be sure to set pin 1 to ON when using the DIP switch.
ON
OFF
1 2 3 4 5 6 7 8
OFF ON
Disabled Enabled
Refer to the table on
the right.
Refer to the table on
the right.
UP DOWN
20 ms 1 ms
H5CX-A@-N/-L@-N
Step2
.
Pin 2 Pin 3 Pin 4
ON ON ON
OFF OFF OFF
ON OFF OFF
OFF ON OFF
ON ON OFF
OFF OFF ON
ON OFF ON
OFF ON ON
Pin 5 Pin 6
Mode A: Signal ON delay 1
OFF OFF
(Timer resets when power comes ON.)
Mode A-2: Power ON delay 1
ON OFF
(Timer resets when power comes ON.)
Mode E: Interval
OFF ON
(Timer resets when power comes ON.)
Mode F: Cumulative
(Timer does not reset when power
ON ON
comes ON.)
Timer
Time range
0.001 s to 9.999 s
0.01 s to 99.99 s
0.1 s to 999.9 s
1 s to 9999 s
0 min 01 s to 99 min 59 s
0.1 min to 999.9 min
0 h 01 min to 99 h 59 min
0.1 h to 999.9 h
Output mode
15