Omron E5ZE Datasheet page 19

Mounting the Controllers
E5ZE-8@AAM@B-E (Casing Type)
Side-by-side, Close Mounting
Saves space and improves wiring efficiency.
Precautions
Correct Use
!WARNING
A lithium battery is used in the Temperature Controller.
Do not take the Temperature Controller apart or allow it to be de-
formed under pressure, heated to 100 C or higher, or incinerated.
The battery may ignite or erupt.
General Mounting Precautions
E5ZE-8@AAM@B-E (Casing Type)
The side of the E5ZE with the terminal block and connectors must
not face up, otherwise operating errors may result.
Prepare four M4 screws to mount the E5ZE to control panels. Use
flat washers and spring washers with screws to mount the E5ZE to
control panels so that the screws will not loosen.
The mounting brackets must be attached to the E5ZE with the four
M3 x 6 screws provided with the E5ZE and each of the screws
should be tightened to a torque of 0.43 to 0.58 N·m, or 4.4 to
5.9 kgf·cm.
Control panel
Control panel
Upside
Upside
Wall Mounting
Can be mounted to places with limited depth.
E5ZE-8@AAM@-E (Open Type)
The side of the E5ZE with the terminal block and connectors must
not face up, otherwise operating errors may result.
Use flat washers and spring washers with screws to mount the E5ZE
to control panels so that the screws will not loosen.
Each of the screws should be tightened to a torque of 0.43 to
0.58 N·m, or 4.4 to 5.9 kgf·cm.
Do not use any mounting stud or screw other than the ones provided
with the E5ZE.
If the stud screws are loose, tighten each of them to a torque of 0.43
to 0.58 N·m, or 4.4 to 5.9 kgf·cm.
Multipoint Temperature Controller
Control panel
Upside
Control panel
Upside
E5ZE
19