Omron E5ZE Datasheet page 18

Mounting the Units
Use appropriate Phillips screwdriver for the screws. Use of an inappropriate screwdriver may damage the screws and cause insufficient tightening.
Mount the Units in an environment where anti-static electricity countermeasures have been taken.
Store the removed screws carefully and use them again when required.
Model With Casing
1. Remove the connector fixing screws (2 screws each for a connec-
tor) from the Units (except for communication unit).
2. Remove the casing fixing screws (6 screws).
3. Remove the casing.
4. Mount the Units in the same manner as the model without casing.
5. Fix the connector to the case using the connector fixing screws
with a torque of 0.34 to 0.39 N·m.
6. Replace the casing in its original position using six casing fixing
screws.
Casing securing
Casing securing
18
Multipoint Temperature Controller
Casing
Case
Remove the casing after removing
the casing fixing screws (6 pcs.)
Identification label for
connector
CT INPUT
CONTROL
ALARM
E5ZE
Model Without Casing
1. Remove the Unit fixing screws.
When CT Input Unit is not required, do not touch the correspond-
ing screws. To prevent the studs from loosening, use a wrench to
fix the studs.
2. Fix the Units in the designated position.
Connect the Units and the E5ZE connector properly.
3. Fix the Units to the studs with fixing screws with a torque of 0.43
to 0.58 N·m.
Fixing studs for the Units
Communication Unit : 3 pcs.
CT Input Unit : 3 pcs.
Output Unit : 4 pcs.
Communication Unit
(sold separately)
E53-E01 or E53-E04
(The diagram shows
E53-E04)
CT Input Unit
(sold separately)
E54-E8CT
Output Unit
(sold separately)
E53-E8Q or E53-E8C
The Unit fixing screws are
mounted on the fixing studs at
the factory.