Accessing A Plc From The Cx-Programmer - Omron CJ2 CPU - REV 10-2010 User Manual

11 Programming Devices and Communications

11-1-3 Accessing a PLC from the CX-Programmer

Procedures in Change PLC Dialog Box
When creating a new project, use the following procedure in the Change PLC Dialog Box to select the
method for connecting to the PLC. This example is for a CJ2H CPU Unit.
1
Select CJ2H in the Device Type Field.
2
Select the method for connecting to the PLC in the Network Type Field. Either of the following
methods can be selected as the default.
• USB
• EtherNet/IP
If required, other network types can be displayed by clicking Show All Button. Select the network
type according to the two conditions shown in the following table.
Condition 1: Type of cable
connected to the PLC
USB
Ethernet
USB
Ethernet
RS-232C
Controller Link (Connected by
Controller Link Board.)
Fins Gateway
11-8
Condition 2
---
Accessing an EtherNet/IP net-
work
Accessing a FINS network via
USB
Accessing an Ethernet net-
work as a FINS network
---
---
---
Network type
USB Displayed by default.
EtherNet/IP
Toolbus (USB port) Displayed by clicking
Show All Button.
Ethernet
Ethernet (FINS/TCP)
Toolbus
SYSMAC WAY
Controller Link
Fins Gateway
CJ2 CPU Unit Software User's Manual