Cutting Out The Counter Top (Only On Models Without Frame With Straight Edge) - Smeg SE2321TE2 Manual

9.5 Cutting out the counter top (only on models without frame with straight
edge)
The illustrations indicate the additional cutting and milling dimensions to be used for the hole made in the
counter top if the hob is to be installed flush with the work surface.
The counter top cutting and milling dimensions are purely indicative; refer to the actual dimensions of
your glass ceramic hob before cutting.
L (mm)
600
770
After laying the adhesive sponge (A) on the glass
surface (see 9.4 Hob seal) and after positioning
and securing the hob, fill the edges with insulating
silicone (B) and wipe away any excess. In the event
the glass surface has to be removed, cut the
silicone using a cutter before attempting to remove
it (C).
Enough silicone must be used to create a seal between the hob and the counter top, but not so much
as to fasten the appliance. To fasten the appliance see "9.7 Fixing using brackets".
54
Instructions for the installer
X (mm) Y (mm)
565 490
745 490
G (mm) H (mm)
604 519
774 519
A (mm) B (mm)
50 min. 50 min.
50 min. 50 min.
C (mm)
750 min.
750 min.