Table of Contents
Advertisement
ead
ching any
vbrations
nponents
ting radj-
juse mal
against a
be trans-
ing feed-
mounted
wt which
matically
BASIC CONNECTIONS
SP-P930
SX-P930'
PD-P930M
CT-P1030WR
@ Accessory AM loop antenna
@ Accessory FM T-type antenna
@) Accessory system cable*
(@ From
Sound
field processor
SP-P930
to Stereo
receiver SX-P930 (white).
@) Speaker cords
@® Speaker system
@) Surround speaker system S-P77 {sold separately}
If other speakers are connected, be sure to use those
with impedance ratings of 16 2 or more.
Only speakers cables with pin-jack connectors can be
used.
® Center speaker (S-P7C)
Other speakers (pin-jack connector type) can also be
connected.
:
Always use speaker impedance between 8 and 16 2.
® To AC wali socket .
*
Power cannot be supplied unless al! four components
are connected as shown.
Plug the power
cord into the AC wall socket outlet
only after all the connections have been completed,
Proceed as follows with the set-up and con-
nections.
1. Place the units from top to bottom in the order
SP-P930,
S$X-P930,
PD-P830M
= and
CT-P1030WR.
System cable connections:
Insert the connector until it locks, thus ensuring that it
is connected. When disconnecting the connector, pull it
in the opposite direction while pressing the left and right
tabs.
5
<ARBI415>
En
|
|
|
|
|
|
Advertisement
Table of Contents
