Advertisement
me PIONEER
CONNECTION
OF SPEAKER SYSTEMS
@The
cords of the speaker systems
that come
with the C-6000A are
provided with plugs.
Plug the cord of the right channel speaker system to the
A SPEAKER
OUTPUT
terminal
(R}. Likewise,
plug the cord of the left channel
speaker system to the
A SPEAKER
OUTPUT terminal
(L).
® Another
set of speaker systems can be connected
to the C-6000A.
When
you
wish
to use another set of speaker systems, connect the
cords of the speaker systems
to the furnished plugs. Plug the cords
from
the speaker systems to the speaker output terminals as in the
case of the furnished speaker systems. When connecting the cords for
the speaker systems to the furnished plugs, be careful not to make a
mistake on the polarity (+, —) and the channels (right or left).
LOUDSPEAKER
SYSTEM
SPEAKER
TERMINALS
SPEAKER PLUG
POSITIVE (-+)
NEGATIVE
(—)
2a,
2POSITIVE
NEGATIVE
Fig. 8
ANTENNA AND GROUND
CONNECTIONS
FM ANTENNA
elf your, house is built with wooden
materials and is located near the
FM station, set up the furnished indoor T-type antenna in the room.
The antenna will provide satisfactory reception of FM programs only
by
adjusting
the
direction.
of the
horizontal
elements.
The
twin
leads from the antenna
should: be connected
with
the FM antenna
terminals. For the operating procedure of reception of FM broadcast,
see 'RECEPTION
OF FM " on page10.
@if your
house
is located
far from the FM
station or is built with
ferroconcrete, installation of an outdoor FM antenna.may be required
for satisfactory
reception
of FM
programs.
Be sure to connect
the
twin leads from the antenna with the FM antenna terminals.
Consult
an audio equipment
shop
in your area for the best type of
outdoor FM antenna.
AM ANTENNA
@Lay
the furnished
AM
antenna
wire on the wall or any appropriate
structure as high as possible, and connect one end of the wire to the
AM
antenna
terminal.
If the indoor
antenna
wire does not provide
satisfactory reception of AM programs, an outdoor antenna should be
erected.
Be suré to connect
one end of the antenna
wire with the
AM antenna terminal.
.
GROUNDING
_For minimum noise, the use of a proper ground is recommended. This
may.
be
either
a water
pipe
or
a ground
rod.
The
lead from
the
ground is connected to the Ground terminal.
FM. T-TYPE
INDOOR
ANTENNA
M INDOOR ANTENNA
en
Fig. 9
27)
FM
OUTDOOR
ANTENNA
AM
OUTDOOR
ANTENNA
GROUND
Fig. 10
Advertisement
