Table of Contents
Advertisement
CASSETTE DECK APPLICATION GUIDE
EAP,
SP trae
©
Ifyou are performing high-speed copying near a tele-
vision, interference (a high-pitched sound) may be
recorded on the tape. If such interference occurs, per-
form copying at normal speed, or turn off the televi-
sion set.
®@ ## you are using a TV in the vicinty of the unit, noise
will be recorded. Either turn off the TV or move it away
from the unit.
34
<ARBI415
>
En
| COPYING TAPES
Duplicating the recorded
contents
of one
tape onto
another tape is known as tape copying. The contents of
the tape in Deck | can be copied onto the tape in Deck
{i (but not vice versa.) Copying is not possible while either
deck is operating. You cannot record a source using the
graphic equalizer.
The deck Il tape is recorded in the same condition as
the deck | tape, regardless of DOLBY NR switch posi-
tion. For example, when copying a Dolby C-type NR
encoded tape, the deck It tape is also recorded with
Dolby C-type NR.
1. Load the recorded tape into Deck | and the tape
for recording into Deck I.
®@ Wind the tape forward past the leader to the start
of the magnetic coating portion.
@ When using tape copy at the high-speed setting,
recording begins from the forward direction (P).
When using tape copy at the normal-speed setting,
recording and playback begin in the directions
shown by the respective lighted indicators on deck
Vand it.
® Make sure there is no tape slack.
2. Select the REV MODE switch.
© To perform normal copying while listening to the
playback, set the receiver's FUNCTION to TAPE,
and set the DOLBY NR switch.
Even if the FUNCTION button is set td another posi-
tion, tape copying will still proceed. The sound of the
program source selected by the FUNCTION button will
be heard through the speakers.
3. Begin tape copy.
® To copy at high speed: Press the COPY button.
© To copy at normal speed: Press the REC PAUSE
button (@ HB) and then press the COPY button,
4. Press the stop button (i) on either deck to stop
the copying at any time.
NOTE:
® During normal-speed tape copying, the REC PAUSE
button { @ HA) and remote control unit's MUTE but-
ton { O / can be used if desired. These buttons can-
not be used, however,
during high-speed copying.
When starting a copy again, press the play button
where the indicator lights.
®
There is variation in actual tape length even among
cassettes of the same length label (C-60, C-90, etc.).
Therefore, even if the recording tape is labeled as the
same length as the playback tape, it is possible for the
recording tape to end first without recording aif of the
contents of the playback tape.
Advertisement
Table of Contents
