Recording Onto A Cassette Tape - Pioneer SX-P930 Operating Instructions Manual

a
ck H but not
erformed us-
}, and load
the exposed
-OSE button
close.
a,
ne prosition
eceiver and
ssSor,
utton (Mm).
e end of tape
fs pressed
the currently
rts playback.
ite tray may
ton { &) is
ronce again
ad
ality sound,
hours).
aning of the
ype" clean-
ictions sup-
ned for use
» there is a
e the clean-
zed service
ot conform
ie tapes.
Ssette tape
'es about 2
BASIC OPERATIONS
RECORDING ONTO A CASSETTE TAPE
4
OPEN/CLOSE
Recording can be performed on Deck II only. Recording
is not possible on Deck J. You can make a recording of
a source which has been processed with the sound field
processor.
1. Press the OPEN/CLOSE button { 4 ), and load
the tape for recording into Deck Il.
® Check to see that the accidental erasure preven-
tion tabs are not broken off.
@ Wind the tape forward past the leader to the start
of the magnetic coated portion.
® Set the cassette in the cassette tray with the ex-
posed tape pointing down. When the OPEN/CLOSE
button is pressed again, the cassette tray will close.
2. Select the REV MODE switch.
==: When recording on one side of a tape.
=> and:
When recording on one side of the tape
and then on the other (from forward to reverse direc-
tion anly).
3. Set the DOLBY NR switch to the desired po-
sition.
® A tape which has been recorded using the DOLBY
NR system must be played back with the same
type.
4, Use the receiver function button to select the
recording device.
Program source | Selected Operation
indicator
Radio broadcast | TUNER | Tune into a broadcast.
Compact disc cD Play a compact disc.
LaserDise LD Play a LaserDisc
2°
<ARBI415>
En