Cautions Regarding Compact Disc Handling; How To Handle Cassette Tapes - Pioneer XR-P770F Operating Instructions Manual

CAUTIONS REGARDING COMPACT
DISC HANDLING
CARE OF DISCS
e When holding discs, do not touch their signal surfaces.
@Do not affix gummed labels or tape to the label surfaces. Also,
do not scratch or damage the disc.
eDiscs rotate at high speed inside the player. Do not use
damaged (cracked or warped) discs.
e Never rub the disc surface with force.
STORING DISCS
@ Always store discs in their cases vertically, avoiding locations
with high heat or humidity, or extremely low temperatures.
@ Always read and abide by the precautionary notes listed on the
disc labels.
CLEANING DISCS
eFingerprints or smudges on the surface of a disc will not
directly affect the recorded signals. Always keep your discs
clean by wiping them gently with a soft cloth from the inner
edge toward the outer periphery.
elf a disc becomes very dirty, dip a soft cloth in water, and after
wringing it out well, wipe the dirt away gently. Remove any
water drops with another soft, dry cloth.
e@Do not use record cleaning sprays or anti-static agents on
discs. Never clean discs with benzene, thinner, or other volatile
solvents, since damage to the disc surface may result.
cleaning
sprays
CD LENS CLEANER
The player's pickup Jens should not become dirty in normal use,
but if for some reason it should malfunction due to soiling,
consult your nearest PIONEER authorized service center. Lens
cleaners for CD players are commercially available, but special
care should be exercised in their use since some may cause
damage to the lens.
16
<ARB7110>
HOW TO HANDLE CASSETTE
TAPES
This will damage the tape itself. To
remove the slack, insert a pencil
into the spool and gently wind it.
Safekeeping
Put the cassette tape back into its
case and store it in a location not
exposedto magnetic field, humidity,
dust, or oil. =,
TIPS ON USING CASSETTE TAPES
Do not use tapes of more than 90 minutes.
Since tapes of more than 90 minutes are so thin, they easily
How can you prevent accidental erasure?
For side A
For side B
Be sure not to cover the tape-type
detection holes.