Cannot Perform Ipl At A Specified Time (No Src) - IBM Application System/400 Service Information

Yes No
Exchange the chassis. See ''Type
and Part Number List" on
page 2-62 to determine the part
and see "Chassis" on page 4-2 for
the procedure.
This ends the procedure.
7
Press the Down button on the control
panel.
Do all of the following occur?
The lights listed in step 6 go off
The 5 x 7 dot pattern for each char-
acter disappears
Only function 01 or 02 appears in the
Function/Data display on the control
panel
Yes No
Exchange the chassis. See ''Type
and Part Number List" on
page 2-62 to determine the part
and see "Chassis" on page 4-2 for
the procedure.
This ends the procedure.
8
This ends the procedure.
Cannot Perform IPL at a
Specified Time (No SRC)
To correct the IPL problem, perform this proce-
dure until you find the problem and can perform
an IPL at a specified time.
1
Perform the following:
a. Verify that the AC power switch is set
to the On position.
b. Verify that the power cable is plugged
into the power outlet.
c. Verify that power is available at the
customer's power outlet.
2
Perform an IPL using the type that the
system is currently set at (A, S, or D) and
mode N.
Note: In N mode, the Dedicated service
tools option will not be shown.
3
Start an IPL by powering on the system
(see "Power on" on page 5-2).
Does the IPL complete successfully?
Yes
No
If there is a reference code, go
to "Unit Reference Code
Tables" on page 2-3.
If there is no reference code,
exchange the chassis. See
''Type and Part Number List" on
page 2-62 to determine the
part and see "Chassis" on
page 4-2 for the procedure.
This ends the procedure.
4
Verify the system date and time by doing
the following:
a. Enter
DSPSYSVAL QIPLDATTIM
(the Display System Value command)
on the command line.
Observe the system value parameters.
Note: The system value parameters
are the date and time the system oper-
ator requested a timed IPL.
Display System Value
System value • • • • • • • • • : QIPLDATTIM
System: seeeeeee
Description • • • • • • • • • : Date and time to automatically IPL
I Pl date • • • • • • • • • : MM/DO/VY
IPl time • • • • • • • • • : HH:MM:SS
Figure
1-3.
Display for QIPLDATTIM
b. Enter
DSPSYSVAL QDATE
(the Display System Value command)
on the command line.
Check the system values for the date.
Chapter 1. Starting Problem Isolation
1-9