Display Incorrect Licensed Internal Code Install - IBM Application System/400 Service Information

Display Incorrect Licensed Internal
Code Install:
If you see the display shown in
Figure 3-22, the Licensed Internal Code has been
installed on a disk unit that is not recognized by
the system as the disk unit using the correct level
of data. Ensure that the displayed disk unit is
operational and perform the Install Licensed
Internal Code again.
Display Incorrect Licensed Internal Code Install
licensed Internal Code has been installed on the incorrect
disk unit of the load-source mirrored pair.
If
you continue the IPL. previously installed Licensed Internal
Code installed on the incorrect disk unit of the mirrored
load-source pair will be deleted. The Licensed Internal Code
will be r$la.ced by the licensed Internal Code from the correct
disk unit. The following disk unit is the correct disk unit.
Disk unit:
Type • • • • • . . . . • • . . . . . • • : 6192
Mode 1 . . . . . . . . . . . . . . . . . : 0010
Serial number . . . . . . . . . . . . • : 10-12345
Address . . . . . . . . . . . e019-8198FFFF
Press Enter to continue the IPL and replace the licensed Internal Code.
F6=lJse Dedicated Serv;ce Tools (DST)
Figure 3-22. Display Incorrect Licensed Internal Code
Install
3-36
AS/400 9401 SelVice Information