Final Operations - Smeg CX61EAG Manual

15. FINAL OPERATIONS

After replacing the nozzles, reposition the flame-spreader crowns, the burner caps and the racks.
Following adjustment to a gas other than the preset one, replace the gas adjustment label fixed to the
appliance with the one corresponding to the new gas. The label is inserted inside the pack together with
the nozzles.
15.1 Adjusting the hob burners minimum for town and natural gas
Light the burner and turn it to the minimum position
knob and turn the adjustment screw at the side of the tap rod until the
correct minimum flame is achieved.
Refit the knob and verify that the burner flame is stable (when turning the
knob rapidly from the maximum to the minimum position the flame must
not go out). Repeat the operation on all the gas taps.
For Valved Models, keep the knob pressed in at the minimum level for a few seconds to keep the flame
lit and to activate the safety device.
15.2 Regulation of the hob burners minimum for liquid gas
In order to adjust the minimum setting with liquid gas, the screw at the side of the tap rod must be
tightened clockwise all the way. The bypass diameters for each individual burner are shown in paragraph
"14.2 Burner and nozzle characteristics table". When the adjustment is completed, restore the sealing of
the by-passes with paint or another material.
15.3 Adjustment of the oven burners minimum
The oven thermostat is equipped with a screw for regulating the minimum, which can be seen by
removing the thermostat knob. When changing the type of supplied gas, the minimum must be adjusted
as follows:
• Light the oven burner and keep it at the the maximum for 10/15 minutes with the door closed and
without the shelf; after this length of time, move the knob to minimum temperature, slide off the knob
and insert a straight edge screwdriver to make the adjustment.
• If using liquid gas the adjustment screw must be tightened clockwise to the very end. The by-pass
diameter is detailed in "14.2 Burner and nozzle characteristics table".
• If using city gas or natural gas, adjust the screw so that when the thermostat knob is turned from
maximum to minimum position the flame remains steady and constant. When the adjustment is
completed, restore the seal on the screws using paint or equivalent materials. When closing the oven
door, make sure the burner remains lit at the minimum.
15.4 Positioning and levelling the appliance (depending on the model)
After making the electrical and gas connections, level the appliance on the floor by means of its four
adjustable feet. For good cooking results, the appliance must be properly levelled.
Depending on the model you have purchased, the foot height adjustment range may vary from 70 to 95
mm and from 110 to 160 mm. These heights refer to the distance between the highest point of the foot
(fixed part) and the lowest point (movable part which rests on the floor).
50
Instructions for the installer
. Extract the gas tap