Final Operations - Smeg CB51GV1 Instructions Manual

5 FINAL OPERATIONS

After replacing the nozzles, reposition the flame-spreader crowns, the burner caps and the pan
stands.
Following adjustment to a gas other than the preset one, replace the gas adjustment label fixed to
the appliance with the one corresponding to the new gas. The label is inserted inside the pack
together with the nozzles.
5.1 Adjusting the hob burners minimum for city and natural gas
Light the burner and turn it to the minimum position
gas tap knob and turn the adjustment screw to the top left of the tap
rod until the correct minimum flame is achieved.
Refit the knob and verify that the burner flame is stable (when
turning the knob rapidly from the maximum to the minimum position
the flame must not go out). Repeat the operation on all the gas taps.
For models with valves, keep the knob at the minimum level for a few seconds to keep the flame lit
and to activate the safety device.
5.2 Regulation of the hob burners minimum for liquid gas
In order to adjust the minimum setting with liquid gas, the screw at the side of the tap rod must be
tightened clockwise all the way. This adjustment is not necessary for the models equipped with a gas
cylinder compartment.
The diameters of the by-passes for the individual burners are given in the paragraph "3.2/3.3 Burner
and nozzle characteristics tables". When the adjustment is completed, restore the sealing of the by-
passes with paint or another material.
5.3 Adjustment of the oven burner minimum
The oven thermostat is equipped with a screw for adjusting the minimum, which can be seen by
removing the thermostat knob.
When changing the type of supplied gas, the minimum must be
adjusted as follows:
•
Light the oven burner and keep it at the maximum for 10/15
minutes with the door closed and without the shelf; after this
length of time, move the knob to the minimum temperature, slide
off the knob and insert a straight edge screwdriver to make the
adjustment.
•
If using liquid gas the adjustment screw must be tightened
clockwise to the very end. The diameter of the by-pass is given
in paragraph "3.2/3.3 Burner and nozzle characteristics tables".
•
If using city or natural gas, adjust the screw so that when the
thermostat knob is turned from maximum to minimum position
the flame remains steady and constant. When the adjustment is
completed, restore the seal on the screws using paint or
equivalent materials. When closing the oven door, make sure
the burner remains lit at the minimum.
44
Instructions for the installer
. Extract the