Table of Contents
Advertisement
OPERATING INSTRUCTIONS
COPY OF THE LIGHTING PLATE INSTRUCTIONS
lyUmilll^lpO^OUR SAFETY READ BEFORE LIGHTING
This appliance must be installed in accordance with local codes, If any; If not,
follow the current CAN1 -B149/ANSI Z 223.1 f Australia: AG601, New Zealand: NZS 5261)
WARNING: If you do not follow these instructions exactly, a fire or explosion rnay result
causing property damage, personal Injury or loss of life. Improper installation, adjustment,
alteration, service or maintenance can cause injury or property damage. Refer to the
owner's information manual provided with this appliance. For assistance or additional
information consult a qualified installer, service agency or gas supplier._
A) This appliance has a pilot which must be lighted by
hand, following the Instructions below exactly.
B) BEFORE LIGHTING smell all around the appliance
area for gas. Be sure to smell next to thefloor because
some gas Is heavier than air and will settle on thefloor.
WHAT TO DO IF YOU SMELL GAS
■ Do not try to light any appliance
- Do not touch any electric switch, do not use any
phone In your building
- Immediately call your gas supplier from a neighbors
phone. Follow the gas supplier's instructions.
■ If you cannot reach your gas supplier, call the fire
department
C) Use only your hand to push in or turn the gas control
knob. Never use tools. If the knob will not push in or
turn by hand, don't try to repair it, call a qualified
service technician. Force or attempted repair may
result In a fire or explosion.
E^Do not use this appliance if any part has been under
water. Immediately call a qualified service technician to
inspect the appliance and to replace any part of the
control system and any gas control which has been
underwater.
This appliance needs fresh airfor safe operation and must
be instailed so there are provisions for adequate
combustion and ventilation air.
CAUTION: Hot while in operation. Do not
touch. Due to high surface temperatures
keep children, clothing and furniture away.
Keep burner and control compartment clean.
See installation and operating instructions
accompanying appliance._
LIGHTING INSTRUCTIONS
STOP! Read the safety information above on this label.
1) Pushingascontrolknobslightlyandtumclockwise
to "OFF". Knob cannot be turned from "PILOT" to
"OFF" unless knob is pushed in slightly. Do not force.
2) Walt five (5) minutes to clear out any gas. If you then
smell gas STOP! follow "B" In the safety Information
above on this label, if you don't smell gas, go to the
next step.
3) Turn knob on gas control counterclockwise
to
"PILOT'.
4) Push in control knob ail the way and hold In.
Immediately push black button on spark Igniter until
pilot lights. Continue to hold the control knob in for
about 1/2mlnute after the pilot is lit. Release knob and
itwillpopbackup.PIlotshould remain lit. If Itgoes out,
repeat steps 3) and 4).
_
If knob does not pop up when released, stop and
Immediatelycallyourservicetechnicianorgassupplier.
lfthepilotwillnotstaylitaflerseveraltrles,turnthegas
control knob to "OFF" and call your service technician
or gas supplier.
5) Turn gas control knob counterclockwise
to
"ON".
6) Use rocker switch to operate main burner.
PILOT BURNER
VEILLEUSE
no
*
THERMOPILE
ELEMENT
THERMO-
ELECTRIQUE
TO TURN OFF GAS APPLIANCE
1) Push in the gas control knob slightly and turn
j
clockwise
to "OFF". Do not force._
2) Turn off all electric power to the appliance If service Is to
be performed._
DO NOT REMOVE THIS INSTRUCTION PLATE
908^9
Advertisement
Table of Contents
