Table of Contents
Advertisement
OPERATING INSTRUCTIONS
1) The FIRST FIRE in your stove is part of the paint curing process.
To ensure that the paint is properly cured, it is recommended that
you burn your fireplace for at least four (4) hours the first time you
use it with the fan on. When first operated, the unit will release an
odour caused by the curing of the paint and the burning off of any
oils remaining from manufacturing. Smoke detectors in the house
may go off at this time. Open a few windows to ventilate the room
for a couple of hours. The glass panel may require cleaning.
DO NOT ATTEMPT TO CLEAN THE GLASS WHILE IT IS STILL
HOT!
Note: When the glass is cold and the appliance is lit, it may cause
condensation and fog the glass. This condensation is normal
and will disappear in a few minutes as the glass heats up.
DO NOT BURN THE APPLIANCE WITHOUT THE GLASS FRONT
IN PLACE.
2) Read and understand these instructions before operating this
appliance.
3) Check to see that all wiring is correct and enclosed to prevent
possible shock.
4) Check to ensure there are no gas leaks.
5) Make sure the glass in the door frame is properly positioned. Never
operate the appliance with the glass removed.
6) Verify that the flueing is unobstructed.
7) Verify log placement. If the pilot cannot be seen when lighting the
unit - the logs have been incorrectly positioned.
8) The unit should never be turned off, and on again without a mini-
mum of a 60 second wait for purging.
WARNING
DO NOT SPRAY AEROSOLS IN THE
VICINITY OF THIS APPLIANCE WHILE
IT IS IN OPERATION
Regency
F33-3 Freestanding Gas Stove
®
OPERATING INSTRUCTIONS
LIGHTING PROCEDURE
IMPORTANT: Gas on/off knob cannot be turned from "PILOT" to
"OFF" unless it is partially depressed.
1) Turn burner OFF using "ON/OFF" switch.
2) Turn gas control knob so indicator points to "OFF" position and allow
5 minutes for any gas in the combustion chamber to escape.
3) Turn gas control knob counterclockwise so indicator points to the
"PILOT" position. Depress the gas control knob fully. Depress the
igniter button several times until the pilot lights. After approximately
one minute, release the gas control knob. The pilot flame should
continue to burn. If the pilot does not remain lit, repeat operation
allowing a longer period before releasing gas control knob.
4) When the pilot stays lit, turn the gas knob further counterclockwise
to the "ON" position.
5) Use the ON/OFF switch, wall switch, thermostat or remote control
to turn on the unit.
6) Rotate the flame height regulator (Hi/Lo) to adjust the flame height
higher or lower.
SHUTDOWN PROCEDURE
1) Use the ON/OFF switch, wall switch, thermostat or remote control
to turn off the burner.
2) Push in the PILOT knob slightly and turn clockwise to off. Do not
force.
3) Turn off all electric power to the appliance if service is to be per-
formed.
13
Advertisement
Table of Contents
