Table of Contents
Advertisement
Simrad AP16 Autopilot
9. Test Autopilot Operation at Sea (refer to Sea Trial
10. Provide the user with training (Page 119)
3.3
Unpacking and handling
Care should be taken when unpacking and handling the
equipment. A visual inspection should be made to see that the
equipment has not been damaged during shipment and that all
components and parts are present according to the packing list.
A standard AP16 autopilot system will include:
− Control unit with standard installation accessories and one
− Autopilot computer (AC10, AC20 or AC40)
− RFC35 Fluxgate Compass with 15 m (49') cable attached.
− RF300 Feedback unit with 10 m (33') cable attached and
− Appropriate drive unit for the installation (unless the AP16 is
− Optional equipment that may have been ordered for the
3.4
Determine system configuration
It is important to become familiar with the configuration of the
system prior to beginning the installation. The AP16 system
layout with options is shown in Figure 3-1
Pay particular attention to the autopilot computer/drive unit
combinations on page 60 and the chart on page 11.
As many of the units are communicating on a common network
(Robnet2), with identical connectors, the installation is
simplified. Try to mount the units within the standard cable
length supplied with each unit, if possible. Robnet2 Extension
Cable (10m) is available from your distributor.
54
d) Automatic tuning
e) Viewing parameters
instructions, pages 99, 118)
15 m (49') Robnet2 cable
transmission rod.
going to operate an existing drive unit or solenoids).
installation.
20221560E
Advertisement
Table of Contents
