Table of Contents
Advertisement
Proceed to the next menu item by pressing the STBD 1 button,
or return to Standby mode by pressing the STBY button.
Transition Speed
The transition speed is the speed where the AP16 will
automatically change the steering parameter set from HI to LO
parameters, or vice versa (page 22).
The default setting of transition speed is 5 kts.
It is recommended that you set the transition speed to a speed
that represents the speed where the hull begins to plane, or the
speed where you change from slow to cruising speed.
The speed used for the automatic transition is obtained with the
following priority:
1. Speed through water from the speed log source.
2. Speed Over Ground (SOG) from the GPS/Chartplotter.
If no speed data is available, manual speed selection is required.
See also chapters 2.8 and 2.9.
Proceed to next menu item by pressing STBD 1 button.
Init NAV
Sets a firm or soft approach to the track line when entering the
NAV mode at the first leg. The approach angle is dependant
(adaptive) on the distance (XTE) from the track line and the boat
speed.
20221560E
Configuration and setup
Use the STBD 10 button to set the
transition speed to the wanted
value in knots.
Range: OFF – 30 knots
Default: 5 kts
Select firm or soft approach to the
track line using the STBD 10 or
PORT 10 button.
Range: Soft - Firm
Default: Soft
107
Advertisement
Table of Contents
