Kyocera TASKalfa 266ci Service Manual page 254

(Disconnect the connectors on the main PWB.)
[For the machine with FAX]
26. Remove two screws and then remove
the FAX control PWB.
[For the machine with the hard disk or the net-
]
work interface card
27. Remove two pins and then pull out the
hard disk or the network interface card.
28. Remove four screws and then remove
the power source shield.
*: Screws A and B are unidentical, Thus, do
not mix up.
(Machine with FAX)
(Machine with the hard disk or
the network interface card)
Figure 1-5-104
Screw A
Figure 1-5-105
1-5-65
2PZ-1
FAX control PWB
Screw
Screw
Hard disk
Screw
Screw
Screw A
Screw B
Power source shield