The Rear Panel - ZyXEL Communications MWR102 User Manual

1.5 The Rear Panel


LAN: Through this port, you can connect the router to your PCs and the other
Ethernet network devices.

WAN: This WAN port is where you will connect the cable/DSL Modem, or Ethernet.

DC IN: Plug the end of the cable firmly into the rear panel of the router, and plug
the other end into a USB outlet to power the system.

WPS/Reset Button: Located on the underside of the device. Click this button to
start PBC configuration method for easy WPS setup.Hold the reset button for 5
seconds or more to reset the system to factory defaults. The system will then
reboot, and approximately 60 seconds later will be ready for further use. The reboot
process cannot be interrupted by powering off the device, or the unit will fail. Before
performing the reset process, ensure the system will be able to finish rebooting!
Warning: Incomplete factory setting recovery procedure will cause the Wireless
Router to malfunction! If you are in this situation, do not try to repair it by
yourself. Consult your local distributor for help!
Figure 2 The rear panel of the Wireless Router.
16