Hardware Installation; Rear Panel - ZyXEL Communications P-330W Quick Start Manual

2 Hardware Installation

2.1 Rear Panel

LABEL
POWER
LAN 1-4
WAN
RESET
Antenna
After you've made the connections, connect the power cable to a power supply and look at the front panel LEDs.
Connect the end of the included power adaptor (use only this adapter) to this power socket.
Use an Ethernet cable to connect at least one computer for initial P-330W configuration. These
ports are auto-negotiating (can connect at 10 or 100Mbps) and auto-sensing (automatically
adjust to the type of Ethernet cable you use (straight-through or crossover)).
Connect your cable/satellite/DSL modem to this port with the cable that came with your modem.
You only need to use this button if you've forgotten the P-330W's password. Push the button for
less than 5 seconds to cause the P-330W to reboot, push for 10 seconds to cause the P-330W to
reset to factor defaults. See your User's Guide for details).
The P-330W uses a RP-SMA connection to attach the antenna for wireless networking. The
antenna will need to be attached here before you can use the wireless LAN.
ZyXEL P-330W
DESCRIPTION
3