LINCOLN ELECTRIC
4. Connect leads 630 and 631 to the top terminals of contactor
5. Using a 5/16" nutdriver, attach the thirteen screws securing the CV box support to the CV box base.
6. Using a 9/16" open-end wrench and a 9/16" nutdriver, attach the nut, bolt, lock washer and three
flat washers securing each side of the CV box to the fuel tank rail (two sets). See Wiring Diagram.
7.
Perform the
Case Cover Replacement
8. Perform the Retest After Repair Procedure.
Procedure.
Figure F.43 – CV box mounting hardware location
Classic® 300 MP Service Manual
CR2. See Wiring Diagram.
79