Lincoln Electric Classic 300 MP Service Manual page 95

LINCOLN ELECTRIC
10. Using a 9/16" open-end wrench and a 9/16" nutdriver, remove the two nuts, bolts, lock washers
and three flat washers (one set in the front and one set in the rear) securing the fuel tank to the fuel
tank rail. See Figure F.57.
11. Carefully slide the fuel tank assembly forward and lift it out of the machine.
12. The fuel tank assembly can now be removed and replaced.
REPLACEMENT PROCEDURE
1. Carefully position the fuel tank assembly into the machine.
2. Using a 9/16" open-end wrench and a 9/16" nutdriver, attach the two nuts, bolts, lock washers and
three flat washers (one set in the front and one set in the rear) securing the fuel tank to the fuel
tank rail.
3. Using a 9/16" open-end wrench and a 9/16" nutdriver, attach the nut, bolt, lock washer and three
flat washers securing each side of the CV box to the fuel tank rail (two sets).
4. Using needle nose pliers, connect the fuel line to the bottom of the fuel tank.
5. Using needle nose pliers, connect the fuel line to the top of the fuel tank.
6. Fill the fuel tank with clean fuel.
7. Connect leads 229 and 5J to the fuel level sensor. See Wiring Diagram.
8. Perform the Output Choke Replacement Procedure.
9. Using a 1/2" nutdriver, tighten the nut securing the negative battery cable to the battery. See
Wiring Diagram.
Case Cover Replacement
10. Perform the
11. Perform the Retest After Repair Procedure.
Procedure.
Figure F.54 – Fuel level sensor location
Classic® 300 MP Service Manual
90