LINCOLN ELECTRIC
REPLACEMENT PROCEDURE
1. Using a 3/8" nutdriver, attach the three screws securing the right case side to the machine.
2. Using a 3/8" nutdriver, attach the three screws securing the left case side to the machine.
3. Remove the fuel cap and fuel cap holder form the machine.
4. Carefully position the roof panel onto the machine.
5. Attach the fuel trough and lift bail cover seal.
6. Attach the fuel cap and fuel cap holder to the machine.
7. Slide the right engine door onto its mounting hinge and close the right engine door.
8. Using a 3/8" nutdriver, attach the screw securing the left engine door.
9. Using a 3/8" nutdriver, attach the four screws securing each side (eight total) securing the roof to
the machine.
10. Using a 3/8" nutdriver, attach the eight screws to the top of the roof.
Figure F.1 – Fuel cap, lift bail cover seal, right engine door, roof panel and case side panel locations
Ranger® 305G EFI Service Manual
24