Extended Response Codes For Failed Connections - Paradyne KeepInTouch 3766 User Manual

Response Codes
Table C-2 describes the Basic response codes supported by
PCMCIA modem (when Q0 and X0 are set).
KeepInTouch
Table C-2. Basic Response Codes
Number Word
Format Format
(V0) (V1)
0 OK
1 CONNECT
2 RING
3 NO CARRIER
4 ERROR
Tables C-3 and C-4 list the Extended response codes. Table C-3
describes the Extended response codes that may appear when
a connection fails. Table C-4 lists the Extended response codes
for successful connections.
Table C-3. Extended Response Codes for Failed Connections
Number Word
Format Format
(V0) (V1)
6 NO DIALTONE The modem has been instructed to wait for a
7 BUSY
8 NO ANSWER
Description
Command Executed
Connection at any rate (if X0 set)
or
Connection at 300 bps.
NOTE: See Table C-3 for other CONNECT
messages.
Incoming ring signal detected on the line
The modem lost carrier signal or did not
detect a carrier signal within the time allowed
by S10.
Invalid command entered. The command
does not exist, or it has a syntax error or a
parameter (variable) which is out of the
allowed range.
Description
dial tone but no dial tone was detected.
The modem tried to place a call and detected
a busy signal.
The modem tried to place a call and did not
detect an answer from the remote modem
within the time allowed by S7.
Issue 2
the
C-3
May 1995