Table of Contents
Advertisement
Using Your Modem
Reload Factory Settings Command (&F)
The modem ships from the factory ready to operate with your
computer and transfer data over a normal telephone line. If you
have changed several configuration options that no longer apply
to what you want to do, you can reload the original factory
template with the &F command.
To use the &F command:
TYPE:
AT&F
PRESS: Enter
The factory settings are loaded into the Active User Profile and
the modem is set up for Data mode.
These are some of the features and functions available to you
when the factory settings are loaded:
G
V.34 operation with a dial line data rate of 28,800 bps.
G
V.42bis data compression when using V.42 error
correction.
G
MNP 5 data compression when using MNP error
correction.
G
Hardware (RTS/CTS) flow control.
G
CD and DTR set for standard RS232 operation.
G
DSR forced on.
G
Response codes enabled, displayed as words (not
numbers).
G
V.34 Automoding, which allows the modem to connect
with non-V.34 modems.
G
Busy and Dial tone detection enabled.
3-12
Issue 2
May 1995
Advertisement
Table of Contents
