Table of Contents
Advertisement
SN
a
eR
I
NT]
Cut editing (continued)
7
Select the playback deck and turn the CLICK SHUTTLE ring on the
VCR until the unwanted event starts.
8
Press EDIT STANDBY/START again when a desired event appears on
the screen.
Editing starts. The indicator above the button lights.
9
Repeat steps 6 to 8 to cut other unwanted events.
Select the playback deck and turn the CLICK SHUTTLE ring on the
VCR until the unwanted event starts.
10 when editing is finished, press EDIT STOP.
11
Press EDIT ON(DIR)/OFF so that the Video8 => VHS or Video' <=
VHS indicator goes off.
To stop the VCR while editing
Press EDIT STOP.
Notes
e When editing from VHS tape to 8 mm tape, note the following:
- If editing is proceeding with a VHS tape that you have recorded, the tape may be
automatically ejected. In this case, check the safety tab. If the tab is removed,
cover the tab hole with adhesive tape and after recording, remove the tape to
protect the recording. Make sure of the direction for recording so that you won't
accidentally erase an important recording.
- If the safety switch on the 8 mm tape to be used as an original tape is slid out so
that the red portion is visible, the tape is automatically ejected. In this case, slide
the switch back in place so that the red portion is not visible. Make sure of the
direction for recording.
¢ Noise may appear at the beginning part of the edited tape.
* When you press If PAUSE or EDIT STANDBY /START while editing from the 8mm
tape to the VHS tape, the picture may turn obscure.
54 | Editing
Advertisement
Table of Contents
