Table of Contents
Advertisement
About This Guide
Document Purpose and Intended Audience
Document Summary
7915-A2-GB20-20
This guide contains information needed to set up, configure, and operate HotWire
Model 7915-A1 E1 SDSL termination units. It is designed for central office and/or
special service installation technicians or network engineers who have an
understanding of digital subscriber line systems and Symmetric Digital Subscriber
Line (SDSL) transmission systems plus the deployment of such systems in a
telephone company or private network environment.
Section
Description
Chapter 1
About HotWire Model 7915 Standalone Termination Units .
Describes the features of each version of the Model 7915
and typical configurations.
Chapter 2
Installing the Unit . Describes how to install the unit and
make connections.
Chapter 3
Using Terminal and Switchpack Modes. Provides
instructions for connecting a VT100-compatible terminal
user interface, and describes how to make manual
configuration changes directly on the board hardware.
Customizing G.703-Compatible Units . Provides instructions
Chapter 4
for modifying configuration options by using the terminal
interface or DIP switches and jumpers on the board.
Chapter 5
Customizing V.35/V.11-Compatible Units . Provides
instructions for modifying configuration options by using the
terminal interface or DIP switches and jumpers on the
board.
Chapter 6
Monitoring the Unit. Describes how to monitor unit status,
LEDs, and network statistics. Also describes how to monitor
the status of the unit on the opposite side of the SDSL
connection.
September 1997
v
Advertisement
Table of Contents
