Table of Contents
Advertisement
G.703-to-V.35/V.11 Configuration
To connect a G.703-compatible unit on the CO side and a V.35/V.11-compatible
unit on the CP side, configure the units as follows. Terminal Mode factory defaults
are in bold (for Switchpack mode defaults, see
V.35/V.11-to-V.35/V.11 Configuration
To connect two V.35/V.11-compatible units, configure the units as follows.
Terminal Mode factory defaults are in bold (for Switchpack mode defaults, see
Appendix
7915-A2-GB20-20
Configuration
V.35/V.11-Compatible Unit
Option
(Customer Premises)
Card Type
CP
Payload Rate
1 – 32 (64 – 2048 Kbps)
Framing,
N/A
Starting Time Slot
E1 Line Code
N/A
Timing
Loop (not configurable)
C).
Configuration
V.35/V.11-Compatible Unit
Option
(Customer Premises)
Card Type
CP
Payload Rate
1 – 32 (64 – 2048 Kbps)
Timing
Loop (not configurable)
September 1997
Worksheets
Appendix
C).
G.703-Compatible Unit
(Central Site)
CO
N/A
If the payload rate is less than
2048 Kbps, select a starting time
slot appropriate for the payload
rate.
If the payload rate is 2048 Kbps,
use Unframed.
HDB3 or AMI
N/A
V.35/V.11-Compatible Unit
(Central Site)
CO
Must be same as CP side
Internal or External
A-3
Advertisement
Table of Contents
