Installing The Unit; Overview; Package Checklist - Paradyne HotWire 7915 User Manual

Installing the Unit

Overview

Package Checklist

7915-A2-GB20-20
This chapter describes the procedure for installing a single standalone
termination unit using a 120 Vac or 230 Vac power supply (Model 7915-A1-20x or
7915-A1-30x).
If you have multiple standalone units at the same location, you may want to
consider installing the units in a HotWire Model 7900 10-Slot Standalone Shelf.
The Standalone Shelf is a convenient method for housing up to ten standalone
termination units and uses only a single power source.
HotWire Model 7915-A1-50x units (which use – 48 Vdc direct power) must be
installed in a HotWire 7900 10-Slot Standalone Shelf. Installation instructions for
these models are not provided in this User's Guide. To obtain information on the
Standalone Shelf, refer to
Guide .
Verify that your package contains the following:
A HotWire Model 7915-A1 standalone unit
VT100-compatible Terminal Cable
A 14 twisted pair network cable
( V.35-compatible units only: includes a ferrite bead for RFI suppression)
Power cord with power transformer (optional)
Warranty card
September 1997
Product-Related Documents
2
on page vi in About This
2-1