Supermicro X13DGU User Manual page 42

Super X13DGU User's Manual
Preparing to Install the PHM into the CPU Socket
After assembling the Processor Heatsink Module, you are ready to install it into the CPU
socket. To ensure the proper installation, please follow the procedures below:
1. Locate four threaded fasteners (a, b, c, d) on the CPU socket.
d
2. Locate four PEEK nuts (A, B, C, D) and four rotating wires (1, 2, 3, 4) on the heatsink
as shown in the graphics below.
A, B, C, D: PEEK Nut
1, 2, 3, 4: Rotating Wire
a, b, c, d: Threaded Fastener
(Unlatched) (Latched)
c
CPU Socket
a
(a, b, c, d: Threaded Fasteners)
B
Rotating Wire 4
D
Rotating Wire
PEEK Nut
d
CPU Socket
42
b
CPU Socket Pin1
Heatsink (Reverse Side)
Rotating Wire 2
A
b
c
a
1U Heatsink
Rotating Wire 3
C
Rotating Wire 1
PEEK Nut