Supermicro X13DGU User Manual page 130

Super X13DGU User's Manual
SATA Port 0 - SATA Port 7 (Available when "SATA Controller(s)" is set to Enabled)
Note: The SATA port naming may vary based on the related configuration.
Hot Plug
Select Enabled to support Hot-plugging for the device installed on a selected SATA port to
allow you to replace the device installed in the slot without shutting down the system. The
options are Disabled and Enabled.
Spin Up Device
Select Enabled for Staggered Spin Up support to allow the SATA devices specified by the
user to spin up one at a time upon at bootup in an effort to prevent all hard drive disks
from spinning up at the same time, causing a power surge. The options are Disabled and
Enabled.
SATA Device Type
Use this feature to specify if the device installed on the SATA port specified by the user
should be connected to a Solid State drive or a Hard Disk Drive. The options are Hard
Disk Drive and Solid State Drive.
Super IO Configuration (Available when your system supports
this feature)
The following information is displayed.
•
Super IO Chip
Serial Port 1 Configuration
Serial Port
Select Enabled to enable serial port 1. The options are Disabled and Enabled.
Device Settings (Available when "Serial Port 1" above is set to Enabled)
This feature displays the base I/O port address and the Interrupt Request address of serial
port 1.
Change Settings (Available when "Serial Port 1" above is set to Enabled)
This feature specifies the base I/O port address and the Interrupt Request address of serial
port 1. Select Auto for the BIOS to automatically assign the base I/O and IRQ address
to serial port 1. The options are Auto, (IO=3F8h; IRQ=4;), (IO=2F8h; IRQ=4;), (IO=3E8h;
IRQ=4;), and (IO=2E8h; IRQ=4;).
130