Supermicro X13DGU User Manual page 147

Intel(R) Ethernet Controller (Ethernet controller)-(MAC address)
Note 1: This feature is available when "Onboard LAN Option ROM Type" is set to EFI.
Note 2: The Ethernet controller and MAC addresses shown above are based on you
system configurations.
Firmware Image Properties
The following information is displayed:
•
Option ROM Version
•
Unique NVM/EEPROM ID
•
NVM Version
NIC Configuration
Link Speed
Use this feature to set the connection speed of a LAN port specified by the user. The options
are Auto Negotiated, 10 Mbps Half, 10 Mbps Full, 100 Mbps Half, and 100 Mbps Full.
Wake On LAN
If this feature is set to Enabled, the LAN port specified by the user will be enabled when
the system is powered on. The options are Disabled and Enabled.
LLDP Agent
Select Enabled to enable the Link Layer Discovery Protocol (LLDP) agent which will provide
the basic device information of a device to other devices on the same Local Area Network
periodically (about 30 seconds). The options are Disabled and Enabled.
Blink LEDs
Use this feature to identify the physical network port by blinking the associated LED indicators.
The default setting is 0 (up to 15 seconds).
The following information is displayed:
•
UEFI Driver
•
Adapter PBA
147
Chapter 4: UEFI BIOS