Table of Contents
Advertisement
JNCSI1
JOCP_SB1/JOCP_SB2
JPDB1
JPRG1
JPWR6
JRSC_PWR1~4
JSTBY1
JTPM1
JVGA1
JUIDB2
JUSBRJ45
J35 (USB 2.0)
J40
JPDB_P12V_STBY
SATA 0-3 (JS1)
SATA 4-7 (JS2)
SW_PWR1
SSATA 0-3 (JS3)
GND and P12V
VROC RAID Key (JRK1)
Note 1: For detailed instructions on how to configure VROC RAID settings, please
refer to the VROC RAID Configuration User's Guide posted on the web page under
the link:
http://www.supermicro.com/support/manuals/.
Note 2: For details on how to configure Network Interface Card (NIC) settings, please
refer to the Network Interface Card Configuration User's Guide posted on our website
under the link:
NC-SI (Network Controller Sideband Interface) connector (See the note below)
OCP Sideband
PDB sideband header
Connector reserved for manufacturer use for onboard CPLD (Complex
Programmable Logic Device) firmware programming
Power connctor for Redstone-Next Transition board (AOM-PCIE5-SXM5-Q)
4-pin power connectors for riser cards
+5V AUX power header
Trusted Platform Module/Port 80 connector
VGA Connector on the rear I/O panel
Rear panel unit identifier switch
Connectors for USB and LAN support
USB 2.0 header
UART header to X170 10G LAN controller
+12V standby power connector
SlimSAS LP (MCIO) connector with support of eight Intel® PCH SATA 3.0
connections (RAID 0, RAID 1, RAID 5, and RAID 10 supported)
SlimSAS LP (MCIO) connector with support of eight Intel® PCH SATA 3.0
connections (RAID 0, RAID 1, RAID 5, and RAID 10 supported)
Power switch
SlimSAS LP (MCIO) connector with support of eight Intel® PCH SATA 3.0
connections (RAID 0, RAID 1, RAID 5, and RAID 10 supported)
+12V power distribution board connection
Intel VROC key header for NVMe RAID support (See the note below.)
http://www.supermicro.com/support/manuals/.
13
Chapter 1: Introduction
Advertisement
Table of Contents
