Table of Contents
Advertisement
14 WHEELS
102
Loosen screw O by several rotations.
Loosen screws
©
Press the screw O with your hand to push the wheel spindle out of the axle
clamp.
Remove screw O-
.
©
©
9
o
D00920-10
Warning
Danger of accidents Damaged brake discs reduce the braking effect.
- Always lay the wheel down in such a way that the brake disc is not
damaged.
A
9
0
<
]
Holding the front wheel, withdraw the wheel spindle. Take the front wheel out of
the fork.
Info
Do not pull the hand brake lever when the front wheel is removed.
I
D00921-10
Remove spacers
©
m
n<=>[
^>0
©
©
M
H00934-10
Installing the front wheel using a work stand
14.7.4
Warning
Danger of accidents Oil or grease on the brake discs reduces the braking effect.
-
Always keep the brake discs free of oil and grease.
-
Clean the brake discs with brake cleaner when necessary.
A
W
Main work
-
Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
- Change the front wheel bearing. (KB p. 103)
-
Clean and grease shaft seal rings O and mating surfaces
o
of the spacers.
(o.
O
tz
O
o.
©
o
«!'=>(]
<
d
=l
^
Long-life grease (KB p. 318)
Insert the spacers.
M
H00935-10
U
W"
© *
Remove the load from the rear of the vehicle.
Lift the front wheel into the fork, position it, and insert the wheel spindle.
S The brake linings are correctly positioned.
Mount and tighten screw
©
Guideline
©
* "j
i /
Screw, front wheel spindle
M24x1.5
45 Nm (33.2 Ibf ft)
m
V:
Operate the hand brake lever several times until the brake linings are seated cor
rectly against the brake disc.
Remove the load from the rear of the vehicle.
©
D00922-10
Advertisement
Table of Contents
