Installing The System Board Assembly - HP ProLiant ML30 Gen10 Plus Maintenance And Service Manual

17. Remove the system board screws (callout 1), and then remove the system board (callout 2).

Installing the system board assembly

Installing the system board assembly
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have the following items available:
T-15 Torx screwdriver or a torque screwdriver with T-15 drill bit
Hex screwdriver—This tool is required only if the serial port cable is to be installed.
HPE ProLiant ML30 Gen10 Plus Server Maintenance and Service Guide 113