Table of Contents
Advertisement
06.2005
11.2.5
Hardware configuration (P052 = 4)
Function
Condition
Result
P052 = 4
P051 = 3
P090 =
P091 =
NOTE
Siemens AG
6SE7087-6CX86-2BA1
SIMOVERT MASTERDRIVES AFE
The purpose of this function is to define option boards (SCB, TSY, CB,
TB) installed in the electronics box of the converter.
The "Hardware configuration" function can be selected in the FAULT
(007), STARTING LOCKOUT (008) or READY FOR ON (009) states.
The LBA bus link (Local Bus Adapter) is required additionally to install
option boards in the electronics box. See Section "Interfaces".
All parameters which can be written in the "Hardware configuration"
state ("H", see right-hand column in "Parameter List") can be altered.
Select "Hardware configuration"
Access level "Expert Mode"
(to be able to alter the following parameters)
Board in slot 2 ( RIGHT in electronics box)
Board in slot 3 ( CENTRE in electronics box!)
Parameter values for P090/P091:
0: No option board
1: CB Communication Board
2: TB Technology Board (P090 only)
3: SCB Serial Communication Board
4: TSY Digital Tacho and Synchronization Board
Slot in electronics box
Left
Slot 1 (CU)
Centre
Slot 3 (options)
Right
Slot 2 (options)
• Only one of each option board type may be inserted in the
electronics box at one time.
• Technology boards (e.g. T300) must always be inserted in slot 2.
The TSY board may not be inserted at the same time as a TB.
• If only one option board is in use, it must always be inserted in slot 2.
♦ Other parameters depending on option boards
(see relevant Operating Instructions or Parameter List).
♦ Make selection between:
Operating Instructions
Boards
CUSA
CB / SCB1 / SCB2 / (TSY, not with TB)
CB / SCB1 / SCB2 / TSY / TB
Parameterization
11-9
Advertisement
Table of Contents
