Table of Contents
Advertisement
Configuring the speakers
Using the remote controller
1. Press the TEST button.
You will hear a pink noise which will be
emitted from the front left speaker.
(1) Remember
the volume level of this noise and then press the CH
SEL button.
The TX-SR601/601E
will now emit the pink noise
from the center
speaker.
(2) Using
the LEVEL
•/V
buttons,
ac[just the volume
level of the
noise from
the center
speaker
so thai it is a/the
same level as
thai was emitted
from the front left speaker.
(3) Press the CH SEL button again. The TX-SR601/601E
will now
emit the pink noise from the front right speaker.
Use the LEVEL
•/V
buttons
to at/just the volume of the noise
from
the front right speaker
so that it is the same
level as that
was emitted
from
the cenler
speaker.
(4) Use the CH SEL button
to select other speakers
and ac[just the
volumes
until all speakers
are adjusted
to the same level.
'Ihe pink noise level can be adjusted
to anywhere
between
12 and
+12
decibels
for
all
speakers
in
1-decibel
increments,
l_k)r
subwoofer,
values between
15 and +12 dB can be set.
2. Press the TEST button
to complete
the procedure.
Buttons used for navigating through the menus
You can change
settings
in the Setup Menu
using the buttons
on the
front panel and on the remote
controller.
The buttons
on the remote
controller
correspond
to those on the TX-
SRT01/701
E/601/601E
as shown
below.
Buttons on TX-SR701/701E/
Buttons on remote controller
601/601E
Displaying
the Main Menu and exiting
the menu
_)
SETUP
_l,
SETUP
Selecting
a menu
or menu item
(upper
edge of
UP
ENTER
button)
(lower
edge of
DOWN
ENTER
button)
T
Setting the value
(left edge of
LEFT
ENTER
button)
(right edge of
RIGHT
ENTER
button)
Selecting
the menu
ENTER
_r_
ENTER
Returning
to the previous
screen
RETURN
RETURN
36
Advertisement
Table of Contents
