Table of Contents
Advertisement
Operating components not reached by the remote
controller signals (IR IN)
In order
to use tile remote
controller
to control
tile TX-SR7Ol/
70 IE/601/601E
from a remote
location,
you will need to prepare a
multi-room
kit (sold separately)
such as one of those given below:
•
Onkyo's
Multi-Room
System
kit
(IR
Remote
Controller
Ex/ension
System)
•
Multiroom
A/V distribution
and control
system
such as those
from Niles °') and Xantech Q')
Make
the
connections
as shown
below.
Do
not
plug
in any
equipment
to the power
outlet until all the connections
are complete.
From connecting
block
Mini plug cable
If the remote controller signal does not reach the
TX-SR701/701E/601/601
E remote sensor
If the TX-SRT01/701
E/601/601E
is located
inside a cabinet
or other
enclosure
where the infrared
rays from the remole controller
cannot
enter, then operation
with the remole
controller
will not be possible.
In such a case, it will be necessary
to install
a remole
sensor
at a
location
outside
of the cabinet
where
the infrared
rays from
the
controller
can reach.
With this connection,
select "Main"
at "HaMware
Config"
-_ "IR
IN Position"
(see page 55).
TX-SR701/701 E/601/601 E
•
IR Receiver
[_
CoLon nectlng
_
_l _
block
_--
IN
_:
TX-SR701/
601E
Remote Controller
;;e
In the
: Signal flow
'Ihe
IR IN input
allows
you to control
the TX-SRT01/701E/601/
601E
h'om
the remole
zone
(Zone
2) with the remote
controller
even
though
the remole
zone
may
be on the
other
side
of the
building
from
the main
zone.
The diagram
below
shows
how to
make the proper
connections
for the remote
zone.
With this connection,
select "Z_me 2" at "Hardware
Config"
-_ "IR
IN Position"
(see page 55).
IR IN
601/_01E
Connectin_
block
Main room
I
IR Receiver
%2
Remote Controller
Zone 2 room
: Signal flow
22
Advertisement
Table of Contents
