HP CX 6300 Installation And Getting Started Manual page 44

Unplugging the DC power supply when the PSU is powered on is not supported.
AC power supply
1. Remove the AC power cable from the connector on the failed power supply.
2. Grasping the handle of the failed power supply, release the locking mechanism by squeezing the latch
handle while removing the failed power supply.
Figure 15 Replacing a Failed Power Supply
Table 12: Replacing Failed Power Supply: Label and Description
1
2
HPE Aruba Networking CX 6300 Switch Series | Installation and Getting Started Guide
Label
Lock mechanism
Handle
Description
44