HP CX 6300 Installation And Getting Started Manual page 21

HPE Aruba Networking X372 54VDC 1600W 110-240VAC Power Supply (JL670A): A 1600 watt (high-line
n
only) power supply for applicable PoE switches. Offers up to 1440 watts of PoE power, and is keyed so that it will
not fit into the power supply slots of non-PoE HPE Aruba Networking switches.
HPE Aruba Networking 6300M 1050W 36-72VDC PSU (JL758A): A 1050 watt power supply used for 6300M
n
PoE switches. Offers up to 740 watts of PoE power, and is keyed so that it will not fit into the power supply slots of
non-PoE HPE Aruba Networking switches.
HPE Aruba Networking 6300M 250W 36-72VDC PSU (JL757A): A 250 watt power supply used for 6300M non-
n
PoE switches. The power supply does not provide any PoE power, and is keyed so that it will not fit into the power
supply slots of the HPE Aruba Networking PoE switches.
Supported DC power supply combinations:
Use of a JL757A with another JL757A PS on the same 6300M non-PoE switch SKU is supported
n
Use of a JL758A with another JL758A PS on the same 6300M PoE switch SKU is supported
n
Mixing of different types of AC and DC power supplies on a 6300M switch is not supported except for the
following combinations:
JL757A is interoperable with the JL085A on the supported 6300M non-PoE SKUs.
n
JL758A is interoperable with the JL087A on the supported 6300M PoE SKUs.
n
For initial power supply installation, see the Start Here guide that pertains to your power supply unit.
Power connector
The 6300M switches do not have a power switch. They will power on when either one or both power supplies are
connected to an active power source.
LEDs on the back of the switches
This section describes the LEDs on the back of the switch. When the back LED on the front of the unit is blinking a
fault, the user can look at the back of the switch to find the corresponding blinking LED for the faulted fan or power
supply. If a user installs a second power supply and did not turn on the power (PSU module status = OFF), the back
LED will blink orange.
Figure 7 Example LEDs on the back of 6300M switch
Table 10: Back of the 6300M switches LED labels and description
Label
1
Description
Fan tray LED
Introducing the switches | 21